Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a little however it's still appealing. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can assist whether the issue is persistent or intermittent.
Water Damage
If you accidentally drop your fob in the midst of a puddle or get it wet when kayaking, swimming, canoeing, rafting or canyoning, it's most likely to sustain water damage. The best way to prevent this from happening is to always keep it in a dry, dry bag when you're outdoors or performing activities where the fob could be exposed to high levels of water.
It's also crucial to make sure that the fob is completely dried out before you open it to use it again. If you smell any odors emanating from the fob (such as industrial fluid or windshield washer fluid), this is another indication that it's submerged.
A circuit board that's damp can cause the battery's charge to drop its energy or even explode. If you can get the 308 keyfob from the water it is best to turn the button side up and shake as much water out as you can before opening the casing. After you open it, remove the battery and wipe the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery or receiver module issue signal interference or a malfunctioning chip. If none of the above are the reason, you may try resetting the system by disconnecting the 12 volt battery for approximately 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start technology that allows drivers to start their vehicle from the distance, allowing them to warm up or cool down the car before entering. This feature is extremely useful particularly during the cold winter months. However, sometimes the remote start system ceases working due to a variety of causes, such as the battery of a coin that is dead.
The coin-shaped battery contained inside the key fob will last between two and four years depending on the frequency with which it is used, where it was purchased, and the way it is used. The date for use-by will be printed on the packaging or in the user manual.
If the key fob stops functioning after being exposed to clean tapwater, take out the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip completely before replacing it. If the key fob was exposed to salty or soapy water, it could have fried the chip. It is necessary to replace it.
If you're not sure the battery is in good condition You can test its voltage using a multimeter set to your car's voltage range and connected to the terminals for minus and plus. If the voltage is less than 12-13 volts then you need to replace the battery. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should be able to start after this.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible that the receiver module has developed a fault. It's the component which sends out a signal when your key fob is activated. It also acts as an alarm and prevents the vehicle from starting without the correct key.
This could be caused by many factors, including water damage or just aging. If your Peugeot 308 key fob has been exposed to dirty tap water, for instance the chip that is located on the inside will be damaged. In this case, you'll need to take it apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. When the battery is dry then you can try again.
If the issue persists then it's a good idea to visit a local Peugeot specialist or locksmith. They can use the diagnostic tool to identify the issue and fix it.
Losing your Peugeot keys to your car can be an extremely stressful experience. A reputable auto locksmith can resolve the issue within minutes. They can program your car and cut a fresh, functioning key for you. Click here to find a local locksmith near you.
A malfunctioning electronic chip
The electronic chip inside the Peugeot 308 key fob is an important part of the remote control system. If peugeot 5008 key becomes damaged, your car might not start or you may receive a message that reads "anti-theft active". If this occurs, the only solution to fix the problem is to get a new key. Professional auto locksmiths can provide this service in the shortest time.
The chip inside the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or any other cause. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to cleanse it immediately. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. The battery should then be allowed to dry completely.
Sometimes, a key fob can not function due to radio interference. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects around the vehicle. It is recommended that you visit a Peugeot dealer if you have this issue.
The Peugeot key fob 207/308 is very delicate and requires attention. It is important not to drop or throw the key fob. If you lose it, try to find it as quickly as you can. You can reset the on-board computer by disconnecting the battery for a couple of minutes. Remove the negative cable before the positive.